1/2 in. Drill Chuck #2MT
Product Description
#2 Morse taper for Delta and Jet lathe headstocks or tailstocks. A 1/2" grip can be used for grabbing small turnings or pen mandrels on the headstock or a drill bit in the tailstock.
Note that to use in the headstock, it must be used with a drawbolt. Draw bolts can only be used with lathes that have a through hole in the headstock. They are threaded into the taper and are kept in place
with a washer and nut on the back end of the headstock. Thread size is 1/4 x 20tpi or 6mm x 1.0.
| Specification | Description |
| Type: | Drill Chuck |
| Compatible Spindle Sizes: | #2 MT |
| Category: | Drill Chucks |
Customer Q & A
Where this item is used:
1/2 in. Drill Chuck #2MT is used in the process of making or using any of the products listed below
Item #: BS21S
Our Price:
Reg Price: $6.95
You Save: $7.00 (18%)
Not yet rated
Item #: BS21SS
Our Price:
Reg Price: $51.70
You Save: $7.00 (18%)
Not yet rated
Item #: BS23S
Our Price:
Reg Price: $6.45
You Save: $7.00 (18%)
Item #: BS24S
Our Price:
Reg Price: $5.95
You Save: $7.00 (18%)
Not yet rated
Get 30% Off! Discount automatically applied at checkout. Offer ends January 5
Item #: PKGRINDW5B
Our Price:
Item #: PKGRINDW5C
Our Price:
Get 30% Off! Discount automatically applied at checkout. Offer ends January 5
Item #: PKGRINDW7B
Our Price:
Get 40% Off! Discount automatically applied at checkout. Offer ends January 5
Item #: PKGRINDW7C
Our Price:
Online prices and selection generally match our online catalog, but may vary. Prices and offers are subject to change.
