Starting and stopping a lathe to check that the blank is perfectly round not only wastes time, but is hard on the electronics when done hundreds of times. Here’s a time-saving solution to alleviate that problem. With the lathe running touch the top of the turned blank against the bottom surface of the turning tool where shown in the photo. If the tool edge rides on the blank without chatter, you know the blank is round. If the tool bounces up and down the least amount, you know you’ve still got a few cuts to make. With a little practice, you’ll be able to feel and hear if a blank is round without having to turn the lathe off to view the surface.
Similar Posts
How to make a bottle stopper
By: Marlen Kemmet A good bottle of wine deserves an equally classy bottle stopper. And few of the stoppers available…
Indent That Center point
Use a sharp pencil and small combination square to mark diagonals to mark the center point on one end of…
An Easy Way to Take Measurements at Your Lathe
We often need to take measurements at the lathe. Rather than constantly worrying about carrying a tape measure, simply use…
Quit Guessing Grits
Unlike sheet abrasives, abrasive strips don’t have the grits marked on the back side, making it easy to lose track…
Make a Tool and Supply Tray for your Lathe Bed
Keep your turning, sanding and finishing tools and supplies close at hand with a custom-built tray. To make the tray…
Sand this way and that
All pen barrels have to be sanded smooth, but how you do that sanding can make a big difference in…